Brother LX-1200 - Manuel (Page 9)

ENGLISH
- 7 -
Part names
Outside of the machine
DC connector Located on the left, backside of the machine. Aperture for the
AC adapter.
Top cover For replacing the film cartridge and cutter units.
Viewing window Located on the top cover. Allows you to make sure that the
correct type of film cartridge is loaded into the machine.
Document tray Where documents to be laminated are placed.
Document supporter Supports the document being laminated.
Document guide Aligns the left edge of the paper for proper document insertion.
Document tray cover Easily lifts for the removal small sized documents.
Control panel Power switch and function button area.
Document output Location where the document exits the machine.
Corner cutter slot Allows you to trim the corners of your document after laminating.
Corners of a document are automatically trimmed after insertion
into the corner cutter slot.
Corner cutter trimmer tray The corner of your laminated document is placed on this tray to
position it into the corner cutter slot.
Corner cutter dust box Collects trimmings from the corner cutter.
AC adapter Plugs into an electrical outlet and the DC connector on the
machine.
Inside of the machine
Film cartridge Contains the roll film. The label on the cartridge identifies the film
type.
You can use 12.0 inch (A3), 9.0 inch (A4) or 4.8 inch (A6) width
LC cartridges with this machine.
Roller holder lever Locks/releases the roller holder.
Roller holder Holds the roller unit.
Side cutter arm Arm for the side (vertical) cutter unit.
Side cutter units Blades for side (vertical) cutting.
Top/bottom cutter units Blades for top/bottom (horizontal) cutting.
Roller Feeds the document into the unit.