Pioneer KRP-WM01 - Manuel (Page 12)

12
En
Installation Procedure
2 Temporarily attach the screw used for positioning about
192 mm (in the case of the KRP-WM01), or 94 mm (in
the case of the KRP-WM02) above the screen center
location.
19
2
m
m
*
94
m
m
**
Screen center
* : KRP-WM01
**: KRP-WM02
Temporarily attach
the screw.
3 Hang the wall side fittings on the screw referred to in
step 2.
Hang the wall side fittings on the screw.
4 Measure the distance from the ceiling to the wall side
fittings (A
1
, A
2
), and the distance from the floor to the
fitting (B
1
, B
2
), and after adjusting the wall side fittings
so that is level, fasten it to the wall with screws or bolts
fitted with supplied washers.
Ceiling
Floor
B 1 B 2
A 1 A 2
A 1 = A 2
or
B 1 = B 2
Screen center
5 Attach the guide labels to the wall and the Pioneer
display and television.
• The guide labels are provisional labels used to indicate
the wall attachment locations.
• First attach the guide labels to an inconspicuous
location on the wall and check that they do not
damage the wall paper.
• Attaching the guide labels to the surface of the
Pioneer display and television may cause adhesive to
remain stuck to the surface, so attach the guide labels
on the rear side of the display as shown in the figure.
15
0
m
m
Attach the guide
labels to the Pioneer
display and television.
Attach the guide
labels to the wall.