NaceCare Solutions TT516 - Manuel (Page 5)

5
The TT 516 is equipped with a large 5 gall clean-water tank allowing large areas to be cleaning in a single fill.
Filling the clean-water tank
To fill the clean-water tank, remove the filler cap (Fig 10).
Fill using a hose, bucket or a suitable container. (Fig 11).
Note.
Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
Fig 10
Fig 11
Machine Set-Up
Fitting the Floor Tool
The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor tool gets snagged, whilst in transit.
The floor tool carrier can be
raised and locked from moving
by operating the locking lever,
upwards and backwards.
this lever can be found next to the
lower section of the handle.
Unlock and swing the floor-tool
carrier to the side of the machine
(Fig 8).
Secure to the carrier using the
two knobs fitted to the floor-tool
carrier (Fig 9) - (Fig 9a).
Do not over tighten the retaining
knobs.
Fig 9
Fig 9a
Note:
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Fig 8
Note The lever moves upward and backward motion to lock the floortool in the raised position.