Yorkville C120P - Manuel

P
rin
te
d
in
C
hi
na w w w . y o r k v i l l e . c o m
Quality and Innovation Since 1963
Yorkville Sound
550 Granite Court
Pickering, Ontario
L1W-3Y8 CANADA
Yorkville Sound Inc.
4625 Witmer Industrial Estate
Niagara Falls, New York
14305 USA
Yorkville C120P Loudspeaker
SPEAKER
Powered
*This Product is Warranted against
manufacturing defects for a period of one year
hank you for choosing Yorkville's Coliseum C120P powered
monitors for your sound reproduction needs. We hope you
will take the time to read this brief manual and if you have any
questions we can be reached online at [email protected].
Front LEDs
Blue LED - indicates power ON.
Orange LED - indicates "clip/limit." The built-in non-defeat-
able LIMITER helps to prevent distortion. It operates
continuously and has minimal effect on sound quality,
however its operation does indicate that the C120P is
at maximum volume and may be on the verge of dis-
tortion if the Orange LED is on more of the time than
simply flashing on peaks.
Controls and Connections
(top to bottom)
TREBLE Control - adjust this control clockwise
or counter-clockwise to increase or decrease
high frequency emphasis. A center setting is
neutral. (See BASS control.)
GAIN Control - turn this control clockwise to
increase the volume, or counterclockwise to
reduce volume. If the orange "clip/limit" LED on
the front of the enclosure illuminates, reducing
the GAIN setting will decrease its activity.
BASS Control - adjust this control clockwise
or counter-clockwise to increase or decrease
the emphasis in the low frequency region. A
center setting is neutral.
Tip: if the orange "clip/limit" LED is illuminating
overtly at comparatively low sound levels, it may
be a result of the BASS being turned up too far.
Reducing the BASS setting will help to compen-
sate. This also applies to the TREBLE control.
¼-Inch BALANCED LINE Input - this is for monophon-
ic, Tip-Ring-Sleeve (balanced), line-level signals and is
not internally connected to the STEREO LINK OUTPUT.
Its main purpose is to provide the mixing technician with
the ability to isolate mixer outputs, or patches, through a
dedicated monitor.
Balancing code is; Tip= (+) 0° phase, Ring= (-) 180°
phase, and Sleeve=Ground.
Tip: if you want to add-on a second C120P, connect
your signal source via the 1/8-inch CD STEREO
LINE IN jack, not the ¼-inch BALANCED LINE input.
Now you can interconnect the second C120P as
stated below.)
1/8-inch STEREO LINK OUTPUT Jack - use a 1/8-inch
stereo cable here to connect an additional C120P. Make
sure the MONO/STEREO button is in the STEREO posi-
tion (down) otherwise the additional speaker will not work.
MONO/STEREO Pushbutton - regulates the signal com-
ing in through the 1/8-inch CD/STEREO LINE IN jack.
Use the STEREO setting when the audio signal is stereo
and/or interconnecting an additional C120P. Use the
MONO setting when no other C120P is linked and you
want Left and Right blended.
Tip: if you are adding another C120P via the
STEREO LINK OUTPUT jack, be sure the MONO/
STEREO pushbutton is in the STEREO position so
that the additional speaker will work
1/8-inch CD/STEREO LINE IN Jack - this is where you
connect your stereo tuner/amplifier, CD player or tape
deck. When used in the recording studio, you may run a
mono line from the mixer to this input rather than the ¼-
inch BALANCED LINE IN jack.
Additional
Your C120P can be painted. We suggest that you remove
the front grill and mask off the speakers and rear connector
panel to avoid getting paint on them. If you want to paint
the C120P without removing the grill, a small amount of
overspray will not hurt the components. However, too much
paint will destroy your speakers permanently.
MADE IN CHINA FABRIQ UÉ EN C HINE
YORKVIL LE SOU ND TORONT O, CANA DA
BALAN CED LINE IN
CD/STE REO LINE IN (from LIN K of SOURCE C 120P)
SECON D C120P
FOR MINI -JAC KS (1/8-inch)
WHEN LIN
KING U SE ONL Y STEREO CABLES
C120P
CD/STE REO LINE IN
LINK OU T
8 0 W a t t s
C120P
Yorkville
230V
50Hz 0.15A
120VAC
60Hz 0.3A
TYPE: YS1025
1v2
WARNING SHOCK HAZARD DO NOT
OPEN
AVIS RISQUE DE CHOC
ELECTRIQUE NE P
AS OUVRIR
RISK OF ELECTRIC SHOC
K DO NOT OPEN
NOT SUIT ABLE FOR IN-W
ALL MOUNTING
WARNING: THE BONDING CO
NDUCTOR IN THIS SUPPL
Y CORD
IS PROVIDED FOR PERFO
RMANCE REASONS ONL
Y
LE CONDUCTEUR DE TERRE DE PROTECTION DANS C
E CORDON
D'ALIMENT ATION EST SEULEM
ENT POUR RAISONS DE PERFORMAN
CE
AVIS RISQUE DE CHOC ELECTRIQUE NE P
AS OUVRIR
Gain
Treble
Bass
Balanced Line In
Link Out
Mono
CD/Stereo Line In
Stereo
Frequency response: 65Hz to 19KHz +/-3dB
Power: 80 Watts burst avg. power
Max SPL: 101dB @ 1 meter
Connectors: 1/4-inch Phone and 1/8-inch Mini Jack
Dimensions: W 17.8 x D 6.5 x H 10.25 inches
W 17.8cm x D 16.5cm x H 26cm
Weight: 8.8 lbs (4.0 kg.)
T
DOC-c120p-spec-00-2v0.pdf