Yorkville CA1T - Manuel (Page 5)

5
Individual zones can be selected by turning these switches on or off. All speakers
connected to a specific zone may be turned on or off in this manner. The ALL switch
overrides the individual switches and switches all zones on, regardless of whether
or not the individual zone switch is on or off.
10. MASTER Volume Control
The setting of this control determines the output level that is present at the loud-
speaker OUTPUT. We recommend to generally adjust the MASTER and the input
level controls at moderate settings. Extreme settings, when the MASTER is set to
maximum output, and the input controls are nearly set to their minimum or vice versa
are not recommended.
11. Common TREBLE Control
When turned clockwise this control enhances the high frequency reproduction, while
turning it counter-clockwise attenuates the treble frequencies. If the control is set to its
center position, the overall frequency response is not being altered.
12. Common BASS Control
When turned clockwise this control enhances the low frequency reproduction, while
turning it counter-clockwise attenuates the bass frequencies. If the control is set to its
center position, the overall frequency response is not being altered.
13. Optional DTS AM/FM Tuner (Only CAIT)
i. Radio ON/OFF and volume control (VOL) The radio can be operated if this knob
is rotated clockwise and an indication appears on the display (ii). Rotate the volume
control clockwise to increase the radio’s output signal level.
ii. Display This display indicates the tuned frequency and memory number.
When the display is off, the radio does not work.
iii. AM/FM Radio Selection Button (AM/FM) Use this button to select the desired
band. The band alternates between AM and FM with each depression of this button.
iv. Tuning Button (UP/DOWN) Use this button to select the desired station. If the
down button is pressed for longer than 1.5 seconds. The AM frequency automatical-
ly decreases at 10kHz intervals, while the FM frequency automatically decreases at
0.1MHz intervals, till the radio is tuned in. To stop the selection manually, press the
down key again during automatic tuning. Similarly, press the UP button will increase
the AM frequency at 10kHz intervals and FM frequency at 0.1MHz intervals. The
selection stops when radio is tuned in or the UP key is pressed again.
v. MEMORY Button If the button is pressed, then press selection button (M1-M5),
the frequency shown on the display is stored together with the memory number.
Stored data is kept for about one week even when the power is not supplied.
vi. Selection Button (MI-M5) Up to five of each of AM and FM stations can be
stored. Press this button for shows the stored station frequency and memory num-
ber on the display (ii).
Rear Panel
PLL AM/FM RADIO
M5 M4 M3 M2 M1 POWER
VOLUME
AM/FM
UP
DOWN
MEMORY
i
ii iii
vi
iv
v