Yorkville MC12D - Manuel (Page 5)

3
mc
12
d
10. Pan Control
The Pan control affects the main-mix signal (only) going to the
L & R masters and the Media Out jacks.
11. Mute Button
The Mute Switch disconnects the specified channel from all outputs.
The channel can still be monitored through the Phones and on the
VU-Meter when the Solo is activated in PFL mode.
12. Clip LED
The Clip LEDs Indicate the input Limiter’s capacity has been
exceeded, reduce the Gain setting when illuminated.
13. Limit LED
The Limit LEDs Indicate input Limiter activity. The bright-
ness of the yellow Limit LED indicates the amount of gain
reduction or compression.
14. Activity LED (Act)
The Act LED indicates channel signal activity (i.e. that signal is
present in the channel).
15. Solo Button
When depressed, the Solo Switch isolates the selected channel
through Phones and on the VU-Meter.
16. Channel Fader
The channel fader sends channel output to the L&R Masters and
the Media outputs.
Input Channels 9/10 and 11/12
1. L&R Line Inputs
The L&R ¼-inch Line Inputs will accept balanced or unbalanced cables from keyboards, etc.
2. Mic Input
The Mic inputs accept standard low-impedance XLR mic-level input.
3. L&R RCA 2-Trk Input Jacks
The L&R RCA 2-Trk inputs can be used for audio signals from CD players, computers, iPods, etc.
4. Gain Control
The channel’s Gain control regulates the L&R Line and Mic input signals.
5. 2-TRK Level Control
The 2-TRK Level Control regulates the 2-Trk (track) input signals only.
Note: Either the Line, or Mic input (not both), can be used along with the 2-Trk inputs
simultaneously.
6. Equalization
The Low and High EQ controls are shelving at 80 Hz & 12 kHz respectively, Mid = bandpass
at 1 kHz, all with +/-15 dB range.
0
5
2 8
7
6 4
3
9 1
10
dB -36 +40
+20 -20
0
-6
+10
9 10
Line
Mic
2-TRK In
2-TRK Level
Gain
24
12
6
8
-
+ +
0
3
0 0
3
24
12
-
0
0 0
1
Mute
Solo
Clip
Lmt
Act