Yorkville PGM8 - Manuel (Page 11)

9
Rear Panel
1. Power Switch and Fuse
The power switch is located on the rear panel. It is unlikely that the fuse would blow but if
there is the suspicion that the fuse has blown first:
i. Confirm that there is 120VAC/230VAC at the point where the PGM8 power plug con-
nects to either a wall plug or an extension cord.
ii. Confirm that the power switch is turned on.
iii. If the PGM8 Power LED is still off disconnect the AC power cord from the PGM8.
iv. Use a screwdriver to slide out the fuse drawer located on the IEC AC power
socket of the PGM8.
v. If visually you can see that the fuse is blown replace with the same type
500mAL sloblo type fuse. It is very important to replace the fuse with exactly
the same type of fuse.
vi. If when powering up the PGM8 with the new fuse the fuse blows again then your
PGM8 may require service from an authorized service technician.
2. Phantom Power Switch
Phantom Power is available for condenser microphones. Even though dynamic microphones
do not need phantom power, having the phantom power turned on will not harm dynamic
microphones. When connecting microphones it is safest to turn off the phantom power to
avoid loud pops. The Phantom Power switch is located on the rear of the mixer. Beside the
Power LED the Phantom Power LED is in the upper right area of the control panel.
To obtain the best performance from your condenser microphones 48 Volt Phantom
Power is available on channels 1 through 8.
3. Main Out XLR Jacks
The main out left and right XLR jacks are located on the rear panel. These are true low
impedance balanced outputs. For the best noise immunity use well shielded XLR cables.
Input Wiring tips:
1. For all input connectivity use shielded wire only. Cables with a foil shield or a high-
density braid are best.
2. When changing input connections, turn down the level controls on the mixer to
eliminate pops and thumps out of the loudspeakers.
3. Keep input connection cables as short as possible to minimize noise and hum.
FUSE: T0.5AL 250V sloblo
ATTENTION: UTILISER UN
FUSIBLE DE RECHANGE DE
MEME TYPE ET CALIBRE
CAUTION: REPLACE WITH
SAME TYPE FUSE AND RATING
DISCONNECT POWER
BEFORE SERVICING!
DEBRANCHER L’APPEREIL AVANT
D’ENLEVER LES COUVERCLES!
THIS UNIT MUST BE
GROUNDED!
CET APPAREIL DOIT
ETRE MIS Á TERRE! DESIGNED BY YORKVILLE SOUND
• TORONTO, CANADA •
MADE IN CHINA
Power
On
On
48 Volt
Phantom
90-264 VAC 50-60Hz
60 VA MAX
MAIN Out
MODEL TYPE:
YS1096
A-PGM8-BK / 3v0