Yorkville NX200S - Manuel (Page 5)


Specifications
Power Amplifier Power (internal)
200 Watts
Frequency response: 50 Hz to 110 Hz
Input Impedance: 80 kohms
Speaker components: 10 inch 2-ohm, 200 Watts
Input Connections
Tip: Positive
Ring(Shaft): Negative
Grounding
The sleeves of the input are not grounded except when the input ground switch
is set to Gnd. Grounding is done through a 10-ohm protection device in order to
prevent damage due to miswiring.
Limiting
Clipping, average voice coil current, thermal
Maximum SPL
125 dB (50 Hz to 110 Hz)
Power Requirements
North American: 110VAC 60 Hz
260 Watts Maximum
European: 230VAC 50 Hz
260 Watts Maximum
Weight
54 lb. (24.5 kg)
dimensions
(WxDxH): 17.5 inch x 27 inch x14 inch
XX... 44.5x68.6x35.6 cm
Note: The nx200s built-in stand mounting adapter can be used with Yorkville
SW-Teletube accessory to support small fullrange cabinets (approximately 16 kg /
35.25 lbs). The support tube can be adjusted up to it's full 5 foot 4 inch extension
safely as long as the nx200s is not inclined more than 10° (10 degrees).
WARNING: Larger/heavier cabinets should not be used with the stand mount!
S
200
Yorkville