Yorkville NX25P-2 - Manuel (Page 5)

3
powered off first (and
powered on last).
Each NX25P Series Two
should be powered
on or off before the
previous NX25P Series
Two in the chain. This
will eliminate unwanted
on/off noises.
Mic Gain
Control
The microphone
level control adjusts
the mic level of the
loudspeaker. It also adjusts the mic level on
all NX25P Series Two enclosures in the chain (if
multiple NX25P Series Two enclosures are used).
Treble and Bass
Controls
These controls affect all
the sound coming out
of a particular NX25P
Series Two enclosure.
These controls do not
affect the sound at the
Mix Out. In a system with
multiple cabinets it will
be necessary to adjust
the Bass, Treble, Mid
and Bass controls on all
individual enclosures.
Limit and Clip LEDs
These LEDs illuminate yellow when signal is
limiting and red when the signal is too large
for the input and is clipping.
LINE IN LEVEL MIC LEVEL POWER LIMIT CLIP
LINE IN LINK MIC
max min max min
0
BASS TREBLE
0
+ -
0
+ -
Bass Treble
+24 PHANTOM
1
3
2
1
3
2
2
3
1
P
300 WATT POWERED LOUDSPEAKER ENCLOSURE
MIC IN MIC GAIN
LINE IN
LINK 250 WATTS
TONE CONTROLS
50 WATTS
LEVEL
30hz/5kHz
5kHz
25