Napoleon Fireplaces Arlington - GDS20 - Manuel (Page 32)

W415-0496 / H / 07.16.13
32
EN
5.1
DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the fi rst 10 hours of operation with a
recommended fi replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
!
WARNING
SCREW
LOCATIONS
ORIFICE
LOCATION
BURNER
ASSEMBLY
A. Remove the cast front and the door, see "GLASS DOOR
/ CAST FRONT INSTALLATION AND REMOVAL" section
in the Finishing section of this manual.
B. Remove the 2 securing screws indicated and remove the
burner assembly.
C. The orifi ce is located on the left hand side.
D. Reinstall the burner ensuring that the venturi tube fi ts over
the orifi ce and replace the screws.
E. Care should be taken not to damage the gas pipe. When
removing and replacing the orifi ce, using a 9/16" socket
wrench, a 7/8" back-up wrench must be used on the
manifold, located below the housing, to ensure that the
aluminum tubing does not twist or kink.
If the pilot indicator light no longer fl ashes and the pilot is
burning, the batteries may require replacing.
Four "AA" batteries are required and should be replaced
annually.
A. Open the switch housing by removing the top
screw, then pivoting the box open.
B. Remove the 4 "AA" batteries and replace using
the new ones.
C. Pivot the box closed and re-secure using the
screw removed in step A.
9.2 PILOT INDICATOR LIGHT BATTERY REPLACEMENT
+
+
+
+
-
-
-
-
9.3 ORIFICE REPLACEMENT
9.4 CARE OF GLASS