Agri-Fab 130 LB.Tow Spreader 45-04631 - Manuel (Page 7)

7
FIGUre 15
STep 15: (See FIGUre 14)
• Slide a 5/8" washer (O), a spacer (L), a 5/8" washer
(O) and a wheel onto the end of the axle with no hole.
• Carefully hammer a hub cap (Z) onto the axle.
FIGUre 14
STep 13: (See FIGUre 13)
• Fasten the hopper braces (11) to the hopper support
tubes using the nylock nuts (J) that were assembled
earlier.
do not tighten completely.
• Fasten the loose ends of the hopper braces to the
hitch tube using a 1/4" x 2" hex bolt (C) and a 1/4"
nylock nut (J).
do not tighten completely.
STep 14:
• Tighten all bolts and nuts except for those shown in
step 10 that fasten the control bracket to the hitch tube.
FIGUre 13
1 2
3 4
5
6
7 8
9
10
SETTING "5"
OF
F
FIGUre 16
STep 17: (See FIGUre 16)
• Set the adjustable stop at "5" and move the control
hande back against it.
• Slide the control bracket along the hitch tube until the
flow plate in the bottom of the hopper is open half way.
• Tighten the bolts and nuts fastening the control
bracket.
Do not deform the control bracket.
• Make sure the flow plate will open and close all the
way. Readjust if necessary.
C
J
J
J
11
11
STep 16: (See FIGUre 15)
• Slide a 5/8" washer (O), a spacer (L), a 5/8" washer
(O) and a wheel onto the end of the axle with a hole.
• Attach the wheel to the axle with a 3/16" x 2" cotter
pin (R).
• Carefully hammer a hub cap (Z) onto the axle.
Z
O
L
O
Z
O
L
O
R