Sony HVL-F43M - Manuel (Page 56)

GB 56
5
Make sure that the built-in flash and flash unit are fully
charged.
• The built-in flash full-charge indication varies depending on the camera.
For details, refer to the operating instructions of the camera.
• When the flash unit is fully charged in the wireless flash mode, the AF
illuminator on the front blinks, and the TEST button is lit in amber.
6
Use test-flash to check the flash.
• During wireless flash photography, the test-flash method differs depending
on the camera used. For details, refer to the operation instructions of your
camera.
• If the test-flash does not work, change the position of the camera, flash, and
subject, or point the wireless control-signal receiver towards the camera.
7
Check again that the built-in flash and the flash unit are
fully charged, and press the shutter button to take the
photo.