Sony SDM-P82 - Manuel (Page 10)

10
G:\4090729111\0490729111SDMP82UC\02US-SDMP82UC\01US02BAS-UC.fm masterpage:Left
SDM-P82
4-090-729-11(1)
If no picture appears on your screen
• Check that the power cord and the video signal cable are
properly connected.
• If NO INPUT SIGNAL appears on the screen:
– The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
– Check that the input signal setting is correct by pressing the
INPUT button repeatedly (page 11).
• If CABLE DISCONNECTED appears on the screen:
– Check that the video signal cable is properly connected.
– Check that the input signal setting is correct by pressing the
INPUT button repeatedly (page 11).
• If OUT OF SCAN RANGE appears on the screen, reconnect
the old monitor. Then adjust the computer’s graphics board in
the following ranges.
For more information about on-screen messages, see “Trouble
symptoms and remedies” on page 19.
No need for specific drivers
The monitor complies with the “DDC” Plug & Play standard and
automatically detects all the monitor’s information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
Setup 6: Adjusting the tilt
This monitor can be adjusted within the angles shown below.
To use the monitor comfortably
Adjust the viewing angle of your monitor according to the height
of your desk and chair, and so that light is not reflected from the
screen to your eyes.
Note
When adjusting the screen tilt, proceed slowly and carefully, being sure
not to hit the monitor against the desk or the base of the display stand.
1 Grasp the lower middle part of the LCD panel while
holding the display stand, then, tilt the LCD panel
adequately backward.
2 Grasp the lower sides of the LCD panel, then adjust
screen tilt.
Horizontal frequency 28 – 92 kHz
Vertical frequency 56 – 85 Hz
Resolution 1280
×
1024 or less
20°
5°
01US01COV-UC.book Page 10 Friday, May 17, 2002 3:51 PM