Samsung DVD-F1080-XAA - Manuel (Page 57)

ENG-57
Reference
C h a p t e r 6
R
E F E R E N C E
Firmware upgrade
Firmware upgrade
appears on the display
Introduction
Samsung will often support the software upgrade
to improve the performance of this unit to the latest
status, through Samsung Internet Site
(www.samsung.com/ca).
Because the specially new mpeg4 codec
continues and it is appearing. What improvements
are made depends on the upgrade software you
are using as well as the software that your DVD-
player contained before the upgrade.
How to make an upgrade disc
Write the downloaded file onto a blank CD-R or
CD-RW disc, using the following settings
:
Upgrade procedure
1. You have to download a new file through Download
Center of Samsung Internet Site
(www.samsung.com/ca).
2. Write the file to Disc using CD-RW of your computer.
Note
- File System CD-ROM ISO Level
- Character set ISO 9660
- Finalized, single session
- Write speed low
1. Open the disc tray. Place the disc on the tray. Close the
tray. The Firmware upgrade screen appears.
Firmware upgrade starts
- In the middle of the writing, the tray will open
automatically. After taking out the disc, please wait for
about 2 minutes.
- If the unit was succesfully updated, the unit will turn off
and on after closing the tray automatically. When the
unit turns on, this screen will display.
3. Press the number buttons to select the desired language.
Note
- If the “Select Menu Language” doesn’t appear,
please contact to “Samsung Service Center”.
- Do not press any button and unplug the power
code during upgrade.
- The upgrade procedure may change, refer to
the web site (www.samsung.com/ca).
2. Press the ¦/‹ buttons to select Total, then press the
ENTER button.