General settings (continued), Language settings, Audio settings – LG RH265 Manuel d'utilisation

Page 18

Advertising
background image

18

General Settings (Continued)

Initialization

You can reset the recorder to its original factory
settings and initialize the HDD.

[Factory Set] If you need to, you can reset the
recorder to all its factory settings. Some options
cannot be reset. (Rating, Password, and Area
Code)

[HDD format] Initializes the HDD (Hard Disk Drive):
everything recorded on the HDD will be erased.

1. Select [Initialize] option then press B.

2. Press v / V to select the desired option then press

ENTER.
The confirm message will appear.

3. Use b / B to select [Yes] or [No] then press

ENTER.

Language Settings

Display Menu

Select a language for the Setup menu and on-screen
display.

Disc Menu/Audio/Subtitle

[Original] Refers to the original language in which
the disc was recorded.

[Other] To select another language, press number
buttons then ENTER to enter the corresponding
4-digit number according to the language code list
in the reference chapter (see page 52). If you enter
the wrong language code, press CLEAR.

[Off] (for Disc Subtitle) : Turn off Subtitle.

Audio Settings

Each DVD disc has a variety of audio output options.
Set the recorder’s Audio Output according to the type
of audio system you use.

Dolby Digital / DTS / MPEG

[Bitstream]: Select “Bitstream” if you connect the
recorder’s DIGITAL AUDIO OUT jack to an amplifier
or other equipment with a Dolby Digital, DTS or
MPEG decoder.

[PCM] (for Dolby Digital / MPEG): Select when
connected to a two-channel digital stereo amplifier.
DVDs encoded in Dolby Digital or MPEG will be
automatically downmixed to two-channel PCM
audio.

[Off] (for DTS): If you select “Off”, the DTS signal is
not output through the DIGITAL AUDIO OUT jack.

Sampling Frequency

If your receiver or amplifier is NOT capable of
handling 96 kHz signals, select [48 kHz]. When this
choice is made, this unit will automatically convert any
96 kHz signals to 48 kHz so your system can decode
them.
If your receiver or amplifier is capable of handling
96 kHz signals, select [96 kHz]. When this choice is
made, this unit will pass each type of signal through
without any further processing.

DRC (Dynamic Range Control)

With the DVD format, you can hear a program’s
soundtrack in the most accurate and realistic
presentation possible, thanks to digital audio
technology. However, you may wish to compress the
dynamic range of the audio output (the difference
between the loudest sounds and the quietest ones).
Then, you may listen to a movie at a lower volume
without losing clarity of sound. Set DRC to [ON] for
this effect.

Advertising
Ce manuel est liée aux produits suivants: