Connections to your tv, Hookup and settings, Scart connection – LG RH265 Manuel d'utilisation

Page 11: Audio (left/right) connection, Component video connection

Advertising
background image

11

Hookup and

Settings

Connections to Your TV

Make one of the following connections, depending
on the capabilities of your existing equipment.

When using the COMPONENT OUTPUT jacks, set
the Video Output Format option in the setup menu
to YP

B

P

R

. When using the SCART jack, set the

Video Output Format option in the setup menu to
RGB.

Tips

Depending on your TV and other equipment you
wish to connect, there are various ways you could
connect the recorder. Use only one of the
connections described below.
Please refer to the manuals of your TV, VCR,
Stereo System or other devices as necessary to
make the best connections.

Caution
– Make sure the recorder is connected directly to the

TV. Tune the TV to the correct video input channel.

– Do not connect the recorder’s AUDIO OUTPUT jack

to the phono in jack (record deck) of your audio
system.

– Do not connect your recorder via your VCR. The

DVD image could be distorted by the copy
protection system.

SCART connection

Connect the AV1 SCART jack on the recorder to the
corresponding in jacks on the TV using the scart cable
(T).

Audio (Left/Right) Connection

Connect the left and right AUDIO OUTPUT jacks of
the recorder to the audio left and right IN jacks on the
TV using the audio cables (A). Do not connect the
recorder’s AUDIO OUTPUT jack to the phono in jack
(record deck) of your audio system.

Component Video connection

Connect the COMPONENT OUTPUT jacks on the
recorder to the corresponding input jacks on the TV
using an Y P

B

P

R

cable (C).

If your television is a high-definition or “digital ready”
television, you may take advantage of the recorder’s
progressive scan output for the highest video
resolution possible. If your TV does not accept the
Progressive Scan format, the picture will appear
scrambled if you try Progressive Scan on the recorder.

Set the Progressive Scan to [ON] on the setup
menu for progressive signal, see page 17.

Caution
Once the setting for Progressive Scan output is
entered, an image will only be visible on a
Progressive Scan compatible TV or monitor. If you set
Progressive Scan to [ON] in error, you must reset the
recorder. First, remove the disc in the recorder. Next,
press STOP (x) and hold it for five seconds before
releasing it. The video output will be restored to the
standard setting, and a picture will once again be
visible on a conventional analog TV or monitor.

Rear of the recorder

L

R

AUDIO INPUT

SCART INPUT

Pr

Pb

Y

COMPONENT VIDEO INPUT

Rear of TV

A

T

C

Advertising
Ce manuel est liée aux produits suivants: