Electrolux EUF2947GOX - Manuel (Page 17)

7.4 Removing the transport support
2
3
Your appliance is equipped with transport
support to secure the door during trans-
portation.
To remove them do these steps:
• Open the door.
• Remove the transport support from the
door sides.
• Remove the transport support from the
lower hinge (some models).
Some models are fitted with a si-
lencing pad under the cabinet. Do
not remove this pad.
7.5 Rear spacers
• Install the spacers provided within the
accessory bag as shown in the figure.
• Install the spacers on the brackets of
the condenser (black grill) at the back of
the appliance.
7.6 Connecting the water hose.
Water supply should be provided with a
tap and 3/4" male connector within 1,5 m
from the appliance.
This work is to be carried out by a skilled
plumber.
There are different type-approved taps
and tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
If this appliance has been purchased to-
gether with the corresponding fridge the
installation should be conducted in such a
way that both appliances share the safety
valve supplied with the fridge.
Should this appliance instead have been
purchased as a single installation or to-
gether with an appliance without water
connection, it is strongly recommended
that a safety valve (1504516–00/4) is in-
stalled. This item can be ordered via
www.electrolux.com.
Before the appliance is placed in its final
location, ensure that the water connection
has been correctly carried out and that
there is no leakage at the connection to
the water tap.
Tighten the connections by hand only.
Make sure that the gasket is properly
positioned in the connector.
ENGLISH 17