Electrolux ERF3867SOX - Manuel (Page 39)

7.6 Connecting the water hose.
Water supply should be provided with a
tap and 3/4" male connector within 1,5 m
from the appliance.
This work is to be carried out by a skilled
plumber.
There are different type-approved taps
and tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
The safety valve provided in a package in-
side the appliance should be used to pre-
vent overflow.
Before the safety valve is placed on the
tap, turn the pointer clockwise to number
10 with the enclosed plastic key.
Install the safety valve on the tap and let
at least 10 litres of water flow through the
device.
Before connecting the appliance turn the
pointer to number 1 on the safety valve.
If the safety valve has shut off, detach it
and press the red plunger which is loca-
ted inside the lower housing of the device
itself.
Before the appliance is placed in final lo-
cation, ensure that the water connection
has been correctly carried out and that
there is no leakage at the connection to
the water tap.
Tighten the screw enough by hand.
Make sure that the gasket is properly
positioned in the connector.
We recommend that the appliance is
placed on a "run-off" mat intended for re-
frigerators and freezers, which makes it
easier to detect possible leakage.
7.7 Levelling
When placing the appliance ensure that it
stands level. If necessary adjust the feet
using the adjustment spanner supplied.
7.8 Installation of the Taste Guard filter
The Taste Guard filter is an active carbon
filter which absorbs bad odors maintain
the best flavour and aroma for all food-
stuffs without risk of odor cross contami-
nation.
On delivery the carbon filter is in a plastic
bag to preserve performance.
• Open the air lever flap.
• Take the filter out of the plastic bag.
ENGLISH 39