American Comfort ACW300C - Manuel (Page 8)

6
Positioning
Installing Exhaust Hose to Window Slide Bar
Note: The window kit is only designed to be installed with sliding windows or doors. The window kit
is not designed or to be used with casement style windows. Measure your window kit according to the
dimensions of your sliding window. If in case the unit is larger than your required dimensions, it can be
cut using a saw or power tool of the sort. If the unit is too short for your opening, you can order an
additional window kit from our online store to extend it.
After assembling Innovative AutoDrain Technology per instructions on page 5,
make sure hose is � rmly attached to oval connector that � ts into window slide bar.
Snap hose connector into window slide bar opening. See Illustration 1.
Extend window slide bar to � t your window opening, either vertical or horizontal,
depending on how the window opens. See Illustrations 2a - 2b.
Important
The � exible exhaust hose can be extended from 12" to 60" for mounting. We recommend
that you keep the hose as short as possible to minimize possible loss back in the room.
This length has been designed especially according to the speci� cations of the
air conditioner.
Do not use an extension or exchange for a different hose as that may lead to
malfunctioning.
The exhaust air must � ow freely. Any blockage ca n lead to overheating of the air conditioner.
Handle with care to prevent any kink or bend in the exhaust hose.
This unit can easily be moved from one room to another. In doing, so keep this in mind:
• The air conditioner must stand upright on an even surface.
• Do not position near bath, sink, or other permanent, wet or damp area.
• Keep unit at least 18" from wall, curtains, draperies, or heat sources to insure adequate
air circulation.
18"
45cm
18"
45cm
1
2 a
2 b