Nexo NXAMP - Manuel (Page 23)

ENGLISH
PAGE
23
MENU DESCRIPTION
USER MANUAL LOAD2_22
DATE: 03/12/2004
2.6 AMP GAIN
Adjustable from 20dB to 40dB nominal Amp Gain in 0.5dB
steps for each channel.
See in “ Amplifiers (Gain, Power)” page 25 a complete
description of this menu, and the way to adjust this setting.
2.7 AMP POWER
Allows you to enter a Nominal Amp RMS power into
8ohms. Adjustable from 200 Watts to 5000 Watts in 50W
steps for each channel.
See in “ Amplifiers (Gain, Power)” page 25 a complete
description of this menu, and the way to adjust this setting.
2.8 Reset measure & Sense Alert
The first section of Menu 2.8 allows you to reset the gain
and power reading to default settings. If the ENTER
WXbutton is pressed, the values are reset, and menu 2.6
is displayed again. Use this feature if any physical changes
have occurred in your system to start again the
measurement process.
Turn the encoder wheel to reach the second section of
Menu 2.8, which is the alert disable menu. Press the enter
WX button to set the alerts (Led flashing) on or off. Once
disabled, the LEDs will not flash if gain settings are
incorrect. This parameter is saved every time the NX242
returns to the default screen, or when a setup is saved in
the menu 1.5.
Configuration select.
3.1 System Config.
Changing a set of parameters within the same family is
made immediately and is barely audible.