Alliance Laundry Systems 802756R3 - Manuel (Page 11)

-11-
802756
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
There are four or five WASH/RINSE temperatures
available – Boosted Hot Wash/Cold Rinse (select
models only), Hot Wash/Cold Rinse, Warm Wash/
Warm Rinse, Warm Wash/Cold Rinse, Cold Wash/
Cold Rinse.
The Energy Saver settings, marked with an
asterisk (*) on some models, show which
temperature settings will use the least energy.
Refer to the Water Temperature section for the
temperature that works best for your garments.
6. Select EXTRA RINSE if desired.
The extra rinse control is useful for detergent
sensitive skin. By pressing the EXTRA RINSE to ON,
the REGULAR, PERMANENT PRESS, and
HANDWASH/DELICATE cycles will each provide an
additional rinse. If the rinse is desired, press the
switch to ON. When the extra rinse is not wanted,
OFF should be selected.
7. Select the cycle according to the type of
fabric being washed. Use the indicator dot on
the cycle selector knob as a guide.
8. Press and hold the START button for two
seconds to start the washer. The DOOR light
will come on after a short delay, water fill will
begin, and wash drum will begin tumbling.
NOTE: Washer door MUST be closed tightly to
start washer.
If items need to be added or removed after a cycle
has started, turn the cycle selector knob to the
OFF position. Wait until the DOOR light goes off
(approximately 45 seconds after cycle has been
stopped), open door, add or remove items, and
start the cycle again.
There is no agitator on this washer. Instead, the
clothing gently tumbles through the water. The
wash action consists of a period of tumbling in one
direction, a brief pause, and then a reverse tumble
in the opposite direction. The pauses are part of
the tumble action and add to the unique cleaning
capabilities of the washer. They are part of the
cycle.
NOTE: There will be extended pauses when
Boosted Hot Wash, if available, is selected
because the water is being heated.
To Change Cycles
If the selected cycle is not the correct cycle for the
fabric being washed, you may change the cycle
selection at any time until the first wash fill is
complete. Once the washer has filled for the first
part of the cycle (the wash portion), the current
cycle must be aborted and a new cycle must be
started.
To change the cycle before the first fill is
complete:
Change the cycle selected on the cycle selector
knob.
WA R N I N G
Window may be hot in the Boosted Hot
and Hot wash cycles.
W325
TLW2078N
TLW2078N