Gotham AF TRT Downlight, Wallwash and EL reflector - Manuel (Page 3)

CJ520483 Rev. B
2/2014 3 of 6
©2009, 20012 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
Upon receipt, thoroughly inspect for any
freight damage which should be brought
to the attention of the delivery carrier.
Compare the catalog description listed on
the packing slip with the label on the
carton to ensure you have received the
correct merchandise.
INSTALLATION INSTRUCTIONS
AF TRT Downlight,
Wallwash and EL reflector
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
Warning: Risk of fire. Do not install
insulation within 3 inches of fixture
sides or wiring compartment, nor above
fixture in such a manner as to entrap
heat.
1. Electric current can cause painful
shock or serious injury unless handled
properly. For you safety, always
remember the following:
• Turn off the supply power.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp surface,
or in water
2.
Specific safety information
concerning lamps:
• Match wattage of fixture and lamp
exactly.
• Do not remove or insert lamp when
power is on.
• Do not scratch glass or subject lamp to
undue pressure as either may cause
lamp breakage.
• Protect operating lamp from sources of
moisture.
• If lamp is marked
it contains
mercury. Follow disposal laws. See:
www.lamprecycle.org.
New Installation for AF Reflector:
1. For 2-lamp trim, attach socket housing to
top of reflector by aligning/inserting corners of
socket housing into raised tabs on top of
reflector. Insert reflector through the ceiling
opening making sure to tilt reflector as shown
in Figure 2.
2. For 1-lamp trim, secure socket cup to
reflector neck (see Figure 1b). Insert reflector
through the ceiling opening making sure to tilt
reflector as shown in Figure 2. Push the
reflector flush against the ceiling.
3. Reference Figure 4 for proper orientation
of wallwash reflector.
4. Install appropriate lamp by inserting tip of
lamp through the opening opposite the socket
housing, aligning base of lamp with socket
and snapping lamp into socket. Refer to label
located inside socket cup for proper lamp
type and wattage. Install lens (if equipped).
5. To remove the reflector: remove lamp(s),
loosen reflector attachment screw and
disengage reflector. Tilt reflector until it
comes through the ceiling opening, loosen
screw in socket housing and remove socket
housing from reflector.
Figure 1
Figure 2
Figure 3
Socket
Housing
Wa
ll
Reflector
Attachment Screw
Yoke shown in
upright position
Socket
Housing Ballast
Reflector
Light
Wallwash
Opening
Raised tabs
Figure 4
Figure 1b