Gotham ICO-SQ Mounting Frame - Manuel (Page 3)

CJ5200912 Rev. C
11/2013 3 of 6
©2010, 2012 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
Non-Flexible Wiring Method
3. If non-flexible wiring method is used, follow procedure for flexible wiring
method. Then lower mounting frame equal to the thickness of the finished
ceiling or slightly above as shown in Figure 4.
4. Remove knockouts on junction box to feed power supply to fixture as
shown in Figure 5. Supply wire must meet applicable electrical codes and
be rated for a minimum for 75°C. Junction box is thru-wire rated for 8-No.
12 AWG conductors (4in-4out). Driver is standard with 0-10V dimming
capability with wires provided by others.
5. Complete necessary splices. Snap the door/driver assembly onto the
junction box as shown in Figure 5.
Figure 6
Housing
frame
Support Wire
Square Housing Post Installation Adjustment
In the event the trim needs alignment after installation, adjustments can be
made to the housing aperture.
1. Remove lower trim by gripping edge of flange and pulling it out of upper
reflector and disengage safety chain.
2. To adjust housing for trim alignment, reach through aperture and loosen
two wing nuts. Adjust housing as required and retighten wing nuts. See
Figure 7.
3. Reinstall lower trim.
Figure 7
Accessing Junction Box
1. Remove lower trim by gripping edge of flange and pulling it out of upper
reflector and disengage safety chain.
2. Slide optical assembly away from the junction box to gain access. Slide
assembly back into position making sure you hear an audible “click”.
3. Reinstall lower trim. Ensure the light engine is centered in reflector
aperture.
Wing Nuts