Hotpoint Ariston CG64SG1(W) F-HA - Manuel (Page 9)

GB
9
*
Only available in certain models.
! If the flame is accidentally extinguished, switch off
the burner and wait for at least 1 minute before
attempting to relight the oven.
Adjusting the temperature
To set the desired cooking temperature, turn the
OVEN control knob in an anticlockwise direction.
Temperatures are displayed on the control panel and
may vary between MIN (150°C) and MAX (250°C).
Once the set temperature has been reached, the
oven will keep it constant by using its thermostat.
Grill
To light the grill, bring a flame or gas lighter close to
the burner and press the OVEN control knob while
turning it in a clockwise direction until it reaches the
d
position. If the appliance is fitted with an
electronic lighting device* ( see figure), press the
OVEN knob and turn it in an clockwise direction,
towards the d position, until the burner is lit. The
grill enables the surface of food to be browned
evenly and is particularly suitable for roast dishes,
schnitzel and sausages. Place the rack in position 4
or 5 and the dripping pan in position 1 to collect fat
and prevent the formation of smoke.
! The grill is fitted with a safety device and it is
therefore necessary to hold the OVEN control knob
down for approximately 6 seconds.
! If the flame is accidentally
extinguished, switch off the
burner and wait for at least 1
minute before attempting to
relight the grill.
! When using the grill, leave
the oven door ajar, positioning
the deflector D between the door and the control
panel (
see figure) in order to prevent the knobs from
overheating.
Turnspit
To operate the rotisserie ( see diagram) proceed as
follows:
1. Place the dripping
pan in position 1.
2. Place the rotisserie
support in position 4
and insert the spit in the
hole provided on the
back panel of the oven.
3. Acitvate the function
by pressing the
TURNSPIT button.
Oven light
The light may be switched on at any moment by
pressing the OVEN LIGHT button.
Timer*
To activate the Timer proceed as follows:
1. Turn the TIMER knob in a clockwise direction 4
for almost one complete revolution to set the buzzer.
2. Turn the TIMER knob in an anticlockwise direction
5
to set the desired length of time.
D