Ohaus I5S Indicator - Manuel (Page 20)

19
Calibration Point Calibration Point Calibration Point Calibration Point Calibration Point
The calibration point is the weight value
that will be used to calibrate the
I 5S. The
available values are listed in the adja-
cent table. A value equal to or less than
the full scale capacity value must be
selected.
To access the current setting, press
when CAL PT is displayed.
1. To change the displayed setting,
press .
2. To accept the displayed setting,
press .
To proceed to the next parameter (Menu
Lockout Switch Setting), press
when CAL PT is displayed.
To exit the Setup submenu and store
your settings, repeatedly press
until END is displayed, then press
to return to the main menu.
To exit main menu and return to a weigh-
ing mode, repeatedly press until
END is displayed then press . The
scale is now in a weighing mode.
Available Values Available Values Available Values Available Values Available Values
5, 7, 10, 15, 20, 25, 30, 40,
50, 60, 75, 100, 125, 150,
200, 250, 300, 400, 500,
600, 750, 1000, 1500, 2000,
2500, 3000, 5000
5000 5000 5000 5000, 7500,
10000
Setup and Calibration 2 2 2 2 2