Activeforever Invacare Bariatric Trapeze (Bariatric Trapeze) - Manuel (Page 2)

Bariatric Trapeze 2 Part No 1106663
Assembling the Trapeze
NOTE: For this procedure, refer to FIGURE 1.
NOTE: Invacare recommends that two (2) people assemble the Bariatric Trapeze.
ƽ WARNING
The weight of the Bariatric Trapeze components are between 17 lbs (7.72 kg) and
21 lbs (9.53 kg). Use proper lifting techniques (lift with your legs) to avoid injury.
1. Remove shipping end caps (yellow) from A‐frame.
2. Insert the base assemblies into the A‐frame.
3. Depress the snap button on one (1) base assembly and slide it into the A‐frame until
the snap button protrudes through the hole in the A‐frame.
NOTE: The base assembly will lock when an audible ʺclickʺ is heard.
4. Repeat STEP 3 for the other base assembly.
5. Slide the mast and boom tube assembly onto the A‐frame, with the boom tube on the
same side as the base assembly legs.
6. Remove the boom tube end cover from the boom tube.
7. Slide the trapeze clamp over the end of the boom tube.
8. Depress the snap button on the boom tube and slide the trapeze clamp toward the
mast until it locks.
NOTE: The trapeze clamp will lock when an audible ʺclickʺ is heard.
9. Replace the boom tube end cover.
10. Adjust the trapeze. Refer to Adjusting the Trapeze on page 3.
FIGURE 1 Assembling the Trapeze
Boom Tube
Mast
Snap
Buttons
Base
Assemblies
A-Frame
Base Assembly Legs
Trapeze Clamp
Snap Button
Boom Tube
End Cover