Whirlpool 2208357 - Manuel (Page 14)

14
4. Remove dirt and lint from the condenser fins and the
unit compartment with a brush attachment on a
vacuum cleaner.
5. Replace the lower access panel using the four screws.
6. Plug in ice maker or reconnect power.
Cleaning the Interior
Components
1. Unplug ice maker or disconnect power.
2. Open the storage bin door and remove any ice that is in
the bin.
3. Remove the drain cap from the water pan and drain
thoroughly. Replace the drain cap.
4. Remove the three screws that hold the cutter grid
cover in place.
5. Unplug the wiring harness from the left side of the
cutter grid.
1. Cutter Grid Cover
2. Screws
6. Unplug the ice level sensor from the right side of the
cutter grid. Pull the ice level sensor down and forward
away from the cutter grid.
7. Remove the right-hand screw and loosen the left-hand
screw. Lift the cutter grid up and out and over the left-
hand screw.
NOTE: Make sure the plastic spacer from the right-
hand side of the cutter grid bracket stays with the
cutter grid.
1. Cutter Grid Harness
2. Screw
3. Cutter Grid
4. Ice Level Sensor Harness
5. Plastic Spacer
6. Screw
8. Remove the two screws that hold the water pan in
place. Push down with one hand on the front of the pan
while pulling forward on the bottom back side.
9. Wash the interior components (cutter grid, exterior of
hoses, and water pan) and the storage bin, door
gasket, and ice scoop with mild soap or detergent and
warm water. Rinse in clean water. Then clean the same
parts with a solution of 1 tablespoon (15 mL) of
household bleach in 1 gallon (3.8 L) warm water. Rinse
again thoroughly in clean water.
NOTE: Do not remove hoses. Do not wash plastic parts
in dishwasher. They cannot withstand temperatures
above 145°F (63°C).
10. Replace water pan by pushing back on the bottom with
one hand while pushing up and back on the top.
Secure the water pan by replacing both screws.
11. Check the following:
■ Drain cap from the water pan is in place.
■ Hose from water pan is inserted into storage bin
drain opening.
12. Slide the cutter grid back into place and secure it by
replacing the right-hand screw and plastic spacer. Then
tighten the left-hand screw. Reconnect the cutter grid
and ice level sensor harnesses.
13. Plug in ice maker or reconnect power.