Whirlpool 2208357 - Manuel (Page 10)

10
3. Remove the two hex head screws from the upper
access panel. Lift up on the bottom of the access panel
to release it from the front of the ice maker. Do not
disconnect the wires.
4. With the upper access panel raised, remove the hinge
pin from the top hinge.
5. Remove the door from the hinges and screw the top
hinge pin back into the top hinge.
6. Replace the upper access panel loosely on the ice
maker.
7. Reverse the door endcaps as follows:
■ Remove both the screws and endcaps (top and
bottom).
■ Place the top endcap on the bottom of the opposite
side of the door with the long flat side facing the
door front.
■ Place the bottom endcap on the top of the opposite
side of the door with the long flat side facing the
door front.
8. Set the door aside.
To reverse the hinges:
1. Unscrew and remove the top hinge. Replace the
screws in the empty hinge holes.
2. Remove the screws from the bottom of the opposite
side of the ice maker cabinet. Turn the top hinge upside
down so that the hinge pin points up. Place the hinge
on the bottom opposite side of the ice maker and
tighten screws.
3. Remove the plastic hinge pin sleeve from the “old”
bottom hinge and replace it on the new bottom hinge
pin.
4. Remove the “old” bottom hinge screws and hinge.
Replace the screws in the empty hinge holes.
5. Remove the screws from the top of the opposite side of
the ice maker cabinet. Turn the hinge upside down so
that the hinge pin points down.
6. Raise the upper access panel and place the hinge on
the top opposite side of the ice maker. Tighten the
hinge screws.
7. Remove the top hinge pin.
To replace door on hinges:
1. Place plastic hinge pin sleeve in the top hinge hole on
the door. Align the door with the top hinge hole and
replace the top hinge pin.
2. Replace the upper access panel and secure it with the
hex head screws.
3. Replace the handle and handle screws.
Top Hinge
1. Hinge Pin
2. Hinge Pin Sleeve
3. Hinge
4. Hex Head Hinge Screw
Bottom Hinge
1. Hex Head Hinge Screw
2. Hinge Pin Sleeve
3. Hinge
4. Hinge Pin
To reverse the door catch:
1. Remove the hole plugs from the opposite side of the
door and set aside.
2. Remove the screws from the magnetic door catch and
replace it on the opposite side of the door.
3. Push the hole plugs into place on the opposite side of
the door.
4. Plug in ice maker or reconnect power.