Whirlpool Ventilation Hood - Manuel (Page 12)

12
5. Install charcoal filter on rear of metal filter with metal wires
provided in filter packaging.
To replace the metal grease filters:
6. Insert back edge of filter into rear track of the filter opening.
7. Push handle toward the rear and push filter up.
8. Pull filter toward the front and insert into front track.
To replace charcoal filter
1. Turn blower and lights off.
2. Remove the metal grease filters by pushing handle toward the
rear and pull downward.
3. Pull filter toward front.
4. Set the filter face down on a protective cover such as a towel.
5. Remove metal wires and clean or discard charcoal filter.
6. Install cleaned or replacement charcoal filter on rear of metal
filter with metal wires provided in filter packaging.
To replace the metal grease filters:
7. Insert back edge of filter into rear track of the filter opening.
8. Push handle toward the rear and push filter up.
9. Pull filter toward the front and insert into front track.
Replacing a lamp
Disconnect the hood from electricity and be sure the lights
are cool.
If new lights do not operate, make sure the lamps are inserted
correctly before calling service.
1. Use a flat bladed screwdriver and gently pry the light cover
loose.
2. Remove the lamp and replace with a 12-volt, 20W maximum,
halogen lamp made for a G-4 base.
3. Replace the light cover.
B
C
A
A. Metal wires
B. Charcoal filter
C. Metal filter
Accessories
Replacement Charcoal Filter........Part Number 4396850