Whirlpool Ventilation Hood - Manuel (Page 10)

3. Screw the upper covers together using 8 screws provided.
4. Push the upper cover assembly up against ceiling.
5. Attach the upper cover assembly to the vent cover support
brackets with two screws (one on each side).
6. Place the lower vent covers around the chimney structure so
that the cover with the captive nuts is to the rear of the hood.
7. Screw the lower covers together using 6 screws provided.
8. Attach the lower cover assembly using 2 screws (one each
side) at the bottom of the vent cover.
A
9. Assemble the lower (narrow) trim strips to the lower vent
cover assembly.
10. Cut the upper (wide) trim strips to length to fit the upper vent
cover assembly.
11. Assemble the upper trim strips to the upper vent cover
assembly.
B
A
10
A. Screw
A. Lower vent cover with captive nuts
B. Upper vent cover
A
B
A. Upper trim strip
B. Lower trim strip