Uniden MHS75 - Manuel (Page 13)

E-9 Uniden MHS75 Radio Owner’s Manual
Scan mode operation
You can save channels into memory and then use scan
mode to monitor those channels from lowest to highest. If the
radio detects a signal on a channel, it stays on that channel
as long as the signal is received; when the signal stops, the
radio continues scanning.
Using the radio in scan mode
To activate scan mode, press • Scan-Dual.
You must have at least two channels in memory to start a •
scan.
You cannot transmit while in scan mode.
•
To save a channel into memory, select the channel, then •
press the Mem button. The Mem icon shows on the display
whenever you tune to that channel.
To remove a channel from memory, set the radio to that
•
channel, then press the Mem button. The Mem icon no
longer shows on the display.
When the radio stays on a channel, press
• Channel Up to
leave that channel and resume scanning.
To end the scan, press the
• Scan-Dual button again; the
radio remains on the last scanned channel.
11 10 08 13 12 14 17 15
The radio scans about
5 channels in 0.5 seconds.
When it detects a signal, the radio stays
on the channel until you press the
Channel Up button or the signal stops.
Resume
scan