Teac Gf-680 Manuel d'utilisation

Page 4

Advertising

Contents

Thank you for choosing TEAC. Read this manual carefully to get
the best performance from this unit.

Before Use

Read this before operation

< As the unit may become warm during operation, always leave

sufficient space around the unit for ventilation.

< The voltage supplied to the unit should match the voltage as

printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.

< Choose the installation location of your unit carefully. Avoid

placing it in direct sunlight or close to a source of heat. Also
avoid locations subject to vibrations and excessive dust, heat,
cold or moisture.

< Do not place the unit on an amplifier/receiver or any other

electronic device that generates heat.

< Do not open the sealed cabinet as this might result in damage

to the circuitry or electrical shock. If a foreign object should
get into the set, contact your dealer or service agency.

< When removing the power plug from the wall outlet, always

pull directly on the plug, never yank the cord.

< To keep the laser pickup clean, do not touch it, and always

close the disc tray.

< Do not attempt to clean the unit with chemical solvents as this

might damage the finish. Use a clean, dry cloth.

< Keep this manual in a safe place for future reference.

DO NOT MOVE THE UNIT DURING PLAYBACK

During playback, the disc rotates at high speed. Do NOT lift or
move the unit during playback. Doing so may damage the disc
or the record.

WHEN MOVING THIS UNIT

When changing places of installation or packing the unit for
moving, be sure to remove the disc and the record. Moving
this unit with the disc or the record loaded may result in
damage to this unit. If the unit is to be packed and moved a
large distance, it is also advisable to tighten the turntable
transport locking screw. See page 12 for instructions.

Beware of condensation

When the unit (or a disc) is moved from a cold to a warm
place, or used after a sudden temperature change, there is a
danger of condensation; vapor in the air could condense on
the internal mechanism, making correct operation erratic or
impossible. To prevent this, or if this occurs, leave the unit for
one or two hours with the power turned on. The unit will
stabilize at the temperature of its surroundings.

Maintenance

Always keep the turntable clean.
If the surface of the unit gets dirty, wipe with a soft cloth or
use diluted mild liquid soap. Be sure to remove any excess
completely. Do not use thinner, benzine or alcohol as they may
damage the surface of the unit. Allow the surface of the unit to
dry completely before using

CAUTION
Do not expose this unit to liquids of any kind. Keep any objects
containing liquids such as vases, water glasses, potted plants,
et cetera off the top of this unit.

Do not install this equipment in a confined space such as a
book-case or similar unit.

Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Before Use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Discs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Cassette Tape . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Handling Records . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

How to Replace the Stylus . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

Remote Control Unit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Names of Each Control (Front Panel/Remote Control Unit) . . . . . 10

Names of Each Control (Turntable). . . . . . . . . . . . . . . . . . . . . . . . . . 12