NuTone VIDEO DOOR VSM4RK - Manuel (Page 9)

2. Repeat step 2 for the remaining mounting bracket.
Existing Construction
1. Position one of the two mounting brackets (ears out) and use two (2) #6 x 3/4" screws (supplied) to attach the brack-
et to the rough-in. Before tightening, slide the bracket so it is flush with the wall surface. Tighten the screws.
2. Repeat step 2 for the remaining mounting bracket.
Connecting Camera at the Monitor
1. Strip approx 2" of outer protective jacket from the category 5 or category 6 cable.
2. Separate and strip approx. 1/2" of insulation from each of the eight wires in the cable. Twist the following cables
together:
• OR and OR/WH
• GR and GR/WH
• BL and BL/WH
• BR and BR/WH
3. Attach each of the twisted pair of wires to the corresponding Camera screw terminals on the back of the monitor.
Tighten each screw securely.
Connecting Optional Handset at the Monitor
If an optional handset has been installed, use the following connection procedure. Refer to the instructions supplied with
9