NuTone VIDEO DOOR VSM4RK - Manuel (Page 8)

4. Attach each of the twisted pair of wires to the corresponding terminal on the back of the camera. Tighten each
screw securely.
5. Dress extra cable and position camera into rough-in.
6. Fully seat the camera into the rough-in. Open the upper and lower
access doors. Attach the camera to the rough-in using a #6 x 1 3/4" screw (supplied) and flat washer (supplied) at
both the top and bottom of the camera. Level the camera, tighten screws and close upper and lower access doors
the master station panel face down to connect wiring.
Important: If camera is exposed to outside elements, caulk should be added to the top and sides of the camera at
the wall surface. Do not caulk bottom surface.
Attaching Monitor Mounting Brackets at the Monitor Rough-in
The VSM4RK monitor is designed to mount in the VRM4R rough-in frame (purchased separately). At the same time the
rough-in is installed, the category 5 or category 6 cable should be ran from the camera rough-in location to the monitor
location and the 120 VAC power cable should be ran to the monitor location. Please refer to the instructions supplied
with the VRC4R rough-in for mounting and wiring information. Before attaching any cable to the monitor, the monitor
mounting brackets must be attached to the VRM4R rough-in. Use the following procedure for attaching the mounting
brackets.
Frame Construction (New Construction)
1. Position one of the two mounting brackets (ears out) and use two (2) #6 x 3/4" screws (supplied) to attach the brack-
et to the rough-in. Before tightening, slide the bracket so it is flush with the finished wall surface. Tighten the
screws.
8
Mounting Screw
and flat washer