Panasonic NC-HU301P - Manuel (Page 21)

21
Cleaning start
Care & Cleaning
Removing scale. (Once every two or three months)
1
Make sure that the mesh filter is attached to the container.
2
Put citric acid in the inner container.
●
Amount of citric acid to be used at one time:
80 g (two packages) or seven level tablespoons.
The citric acid is available from an authorized dealer. (Model No: SAN-80N)
* Follow the directions for cleaning printed on the citric acid package.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
3
Add water to the maximum water level mark, and
mix the citric acid and water well. Close the lid.
Citric acid
4
Connect the plug, and choose in .
5
Unplug, remove the lid and empty the hot water via the “DRAIN” mark.
6
Refill with water and boil it to remove the smell of the citric acid or lemons.
Then throw the hot water away in the same manner as
5
.
●
To remove any discoloration from the area above the maximum water level, rub the inside lightly
with a wet non-abrasive sponge.
●
If the discoloration cannot be removed by rubbing, clean the inner container several times using
citric acid or lemons.
●
When washed without removing charcoal filter, wash the active charcoal filter, fix it in the inner
container and throw out the initial boiled water before use.
●
Make sure to only use citric acid for thermo pot washing.
●
Do not fill with water above maximum water level.
●
Fill the container only with tap water (do not fill with hot water). Hot water may spout out causing burns.
End of cleaning
How to clean with citric acid
beep beep
beep beep
Light on
Cautions
NC-HU401_301-EN-6.indd 21 11/12/08 2:35:56 PM