Pioneer ELITE SX-A9MK2-K - Manuel (Page 8)

Connecting up 02
8
En
Chapter 2:
Connecting up
Making cable connections
Make sure not to bend the cables over the top
of this unit (as shown in the illustration). If this
happens, the magnetic field produced by the
transformers in this unit may cause a
humming noise from the speakers.
Important
• Before making or changing any
connections, switch off the power and
disconnect the power cord from the AC
outlet.
Connecting audio components
The number and kind of connections depends
on the kind of component you’re connecting.
Follow the steps below to connect a CD player,
tape recorder, turntable or other audio
component.
1 Connect the analog audio outputs of your
CD player (or other component) to the CD
inputs on this receiver.
Use a stereo RCA phono cable as shown.
MM/MC
PRE
OUT AUX1 AUX2 CD PHONO
L
R
GND L
R
FM UNBAL
75
AM LOOP
12V TRIGGER
ANTENNA USB
AUDIO IN
SIGNAL
CONTROL XM
IN
IN
IR OUT
OUT
TAPE
IN
PLAY
OUT
REC
R
L
AUDIO IN/OUT
OUT
R L
AUDIO OUT
1 2
PLAY
OUT IN
REC
3
Turntable
Tape deck, etc.
This receiver
CD player, etc.
D6
A9MK2_CUXCN.book 8 ページ ２００９年４月７日 火曜日 午前１０時２６分