Pioneer ELITE SX-A9MK2-K - Manuel (Page 21)

Other connections 06
21
En
English
Using the USB interface
It is possible to listen to two channels of audio
from your computer by connecting to the USB
interface on the rear of this receiver.
Depending on your model of computer and the
software installed, you can listen to the stereo
audio source through the speaker setup you’ve
connected to this receiver.
1
1 Connect your computer’s USB terminal to
the USB terminal on the rear panel of this
receiver.
2 Switch on your computer and this
receiver.
3 If you’re connecting for the first time,
wait for the USB driver installation to finish.
The installation may take a minute or two to
complete. Make sure you leave the USB cable
connected until the dialog box indicates that
the USB setup is finished. Note that some
older operating systems may require a disc for
installation.
2
4 Press USB to select the USB input.
You can also use the INPUT SELECTOR dial on
the front panel.
5 Make any necessary settings required to
select the USB interface as your computer
audio output.
You will need to make sure the correct speaker
setting is selected with the audio software
you’re using. Please refer to the manual that
came with the software to make these settings.
6 Turn up the volume control on your
computer and this receiver.
You may want to start with a fairly low volume
on this receiver and turn it up as necessary
after you’ve checked your levels.
7 Start playback of a source on your
computer.
Important
If you have followed the steps above, and still
can’t hear any audio output, try the following:
• Switch the receiver off, then on again.
• Selecting another input source (like CD or
TAPE), then back to USB.
Note
1 • Microsoft ® Windows ® Vista Home Basic/Home Premium/Business/Ultimate,Windows ® XP, Windows ® 2000, Windows ®
Millennium Edition and Windows ® 98 Second Edition operating systems have been tested for compatibility, but depending on
your computer setup, you may find that your system is not compatible.
• Make sure your USB cable connects from an A-type connector (from your PC) to a 4-pin B-type connector (to this unit).
• The USB specification is version 1.1 compatible, and the USB Audio Class specification is version 1.0 compatible.
• Computer alert sounds will also be heard through the speakers unless you disable them from the computer’s control panel.
• You won’t be able to hear the audio from the USB connection through the digital outputs of this unit.
• Note that using hubs or extensions may cause connection problems.
MM/MC
PRE
OUT
AUX1 AUX2 CD PHONO
L
R
GND
L
R
FM UNBAL
75
AM LOOP
12V
TRIGGER
ANTENNA
USB
AUDIO IN
SIGNAL
CONTROL XM
IN
IN
IR
OUT
OUT
TAPE
IN
PLAY
OUT
REC
This receiver
A-type USB
connector
B-type USB
connector
2 If your PC doesn’t recognize this unit, try reconnecting the USB cable. If it is still unrecognized, restart the computer.
A9MK2_CUXCN.book 21 ページ ２００９年４月７日 火曜日 午前１０時２６分