Pioneer DEH-P960MP - Manuel (Page 63)

Understanding built-in CD
player error messages
When problems occur during CD play an error
message may appear on the display. If an
error message appears, refer to the table
below to see what the problem is and the sug-
gested method of correcting the problem. If
the error cannot be corrected, contact your
dealer or your nearest Pioneer Service Center.
Message Cause Action
ERROR-11, 12,
17, 30
Dirty disc Clean disc.
ERROR-11, 12,
17, 30
Scratched disc Replace disc.
ERROR-10, 11,
12, 17, 30, A0
Electrical or me-
chanical
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the CD
player.
ERROR-22, 23 The CD format
cannot be played
back
Replace disc.
ERROR-44 All tracks are
skip tracks
Replace disc.
Understanding auto TA and
EQ error messages
When correct measurement of car interior
acoustic characteristics is not possible using
the auto TA and EQ, an error message may ap-
pear on the display. If an error message ap-
pears, refer to the table below to see what the
problem is and the suggested method of cor-
recting the problem. After checking, try again.
Message Cause Action
MIC Error Microphone is
not connected.
Plug the supplied
microphone se-
curely into the
jack.
Front SP Error,
FL speaker
Error, FR
speaker Error,
RL speaker
Error, RR
speaker Error,
Subwoofer
Error
The microphone
cannot pick up
the measuring
tone of a speaker.
! Confirm that the
speakers are con-
nected correctly.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Set the micro-
phone correctly.
Noise Error The surrounding
noise level is too
high.
! Stop your car in
a place that is as
quiet as possible,
and switch off the
engine, air condi-
tioner or heater.
! Set the micro-
phone correctly.
Not available The operation
mode is set to
NW mode.
The auto TA and
EQ function does
not work in NW
mode.
Understanding error
message on rewriting the
entertainment displays
When problems occur during rewriting the en-
tertainment displays an error message may
appear on the display. If an error message ap-
pears refer to the table below to see what the
problem is and the suggested method of cor-
recting the problem. If the error cannot be cor-
rected, contact your dealer or your nearest
Pioneer Service Center.
Message Cause Action
CD ERROR CD player error Press EJECT and
check the disc.
Additional Information
En
63
English
Appendix