Switching off the projector, Switching the projector on/off, Nglish – Panasonic TQBJ0302 Manuel d'utilisation
Page 22
Switching the projector on/off
Basic Operation
22 -
E
NGLISH
Switching off the projector
When operating the projector, check the status of the
POWER indicator. (
INPUT SELECT
RELEASE
POWER indicator
POWER LOCK indicator
(1), (2)
Press the POWER button.
1 )
The confirmation screen will be displayed.
Without any operation for 10 seconds or press any button other than the
z
POWER button, the confirmation
screen will go off and return to the projection.
Press the POWER button again.
2 )
The lamp goes off, the operational sound (beep) sounds, and projection stops.
The cooling fan continues its rotation and
z
POWER indicator lights in orange. Wait until the POWER LOCK
indicator and
POWER indicator turn into red.
If
z
STANDBY MODE is set to NORMAL, the POWER indicator flashes in red. (
You can set to
z
ON or OFF the beeping sound that occurs when the POWER button is in operation in
AUDIO SETTING.
After the POWER LOCK indicator and POWER indicator light in red, disconnect the
3 )
power plug from the wall outlet. (
For urgency, you may disconnect the power plug immediately since the
z
DIRECT POWER OFF function is
installed.
Remarks
Confirm that
z
CONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER (when
operating with the remote control) under
CONTROL DEVICE SETUP in the SECURITY menu is set to ENABLE.
You can switch off the power by pressing the
z
POWER button for 0.5 seconds or more.