Philips 32PFL7704D - Manuel (Page 27)

25
2
Press OK to start the installation.
• If you run [Autoprogram] on locked channels, you must to
enter your PIN code.
• If you have forgotten your PIN, reset it .
3
Select [Cable] or [Antenna] and press OK .
• When [Antenna] is selected, the TV detects antenna signals.
It searches for NTSC and ATSC channels available in your
area.
• When [Cable] is selected, the TV detects signals supplied
by cable. It searches for NTSC, ATSC, and QAM modulated
channels available in your area.
• When complete, this message appears [Channel search
completed.] .
4
Follow the on-screen instructions to complete the installation.
Optimize the signal quality from your
antenna
You can optimize your signal quality by tuning in ATSC channels with
weak signals, and adjusting the antenna.
1
Press MENU/EXIT on the remote control and select
[Installation] > [Channels] > [Installation mode] mode .
2
Select [Antenna] and press to confi rm your choice.
3
Press and to enter [Weak channel installation] .
4
Highlight a channel from the list of TV channels and press the
green color button on the remote control.
» The signal strength for the channel is displayed.
Autoprogram
Start Now
Autoprogram
Weak channel installation
Installation mode
Uninstall channels
Channels
TV menu Installation
System searching. Please wait...
Analog channels found: 0
Digital channels found: 0
TV installation
7 Install channels
The fi rst time you setup your TV, you are prompted to select a menu
language and to install TV and digital radio channels (if available). This
chapter provides instructions on how to reinstall and fi ne tune channels.
Select your menu language
1
Press MENU/EXIT on the remote control and select
[Installation] > [Language] .
2
Select a language and press OK to confi rm your choice.
3
Press to return to the [Installation] menu.
Set your location to home
You can set the location of your TV to home or retail store. Choose
home so that you can change the predefi ned settings for picture and
sound.
1
Press MENU/EXIT on the remote control and select
[Installation] > [Preferences] > [Location] .
2
Select [Home] and press OK to confi rm your choice.
3
Press to return to the [Installation] menu.
Automatically install channels
Before you install channels, ensure that you are registered with your
cable TV provider and that your equipment is correctly connected.
1
Press MENU/EXIT on the remote control and select
[Installation] > [Channels] > [Autoprogram] > [Start now] .
Language
English
Francais
Espanol
Installation
TV menu
Language
Channels
Preferences
Source labels
DivX® VOD
Current software info
Clock
Reset AV settings
English
EN