Panasonic DP-3010 - Manuel (Page 191)

Customizing Your Machine
191
Fax Parameter Table
S
e
tt
ing Y
o
u
r
Mac
h
in
e
017 Receive Mode Manual Setting the reception mode to automatic or manual.
*Auto
022 Substitute Receive Invalid Selecting whether the machine receives to memory when the recording
paper runs out, toner runs out or the recording paper is jammed.
*Valid
024 Print Reduction Fixed Selecting print reduction mode.
Fixed : Reduce received document according to setting of Parameter
No. 25.
Auto : Automatically determines and reduces the incoming document
to print onto the paper loaded in the machine.
*Auto
025 Reduction Ratio 70% Selecting the fixed print reduction ratio from 70% to 100%. This
parameter functions only when the fixed print reduction is selected on
Fax Parameter No. 24.
----
100%
026 Polling Password (----) Setting a 4-digit password for secured polling. (See page 46)
027 Polled File Save *Invalid Selecting whether the machine retains the polled document in memory
even after the document is polled once.
Valid
028 Stamp at MEM. XMT Invalid Selecting whether the machine stamps the original documents when
storing the documents into memory.
(Depends on the Stamp setting on the Control Panel)
*Valid
031 Incomplete File Save *Invalid Selecting whether the machine retains the document in memory if the
document is not successfully transmitted.
Valid
033 XMT Reduction Invalid Selecting whether the machine performs reduction when the
transmitting original is wider than the recording paper used at the
receiving machine.
*Valid
037 Receive to Memory (----) Enter a 4-digit password for printing the received document(s) in
memory by using
.
When is set to ON, this parameter is not
selectable on the LCD display. (See page 83)
039 PIN Code Access *None Selecting the access method (Prefix or Suffix) to dial a number with PIN
Code. (See page 88)
Suffix
Prefix
042 Conf. File Save *Invalid Selecting whether the machine saves the confidential polled file even
after the file is polled once.
Valid
043 Password-Transmit *Off Setting a 4-digit XMT-Password and selecting whether the machine
performs and checks the XMT-Password of the receiving station when
transmitting. (See page 77)
On
* = Factory default setting
No. Parameter Setting Comments
MODE SETTING SELECT MODE RECEIVE TO MEMORY
RECEIVE TO MEMORY
Continued on the next page...