KITCHENAID 528534 - Manuel (Page 7)

7
Option 2: Garbage disposal connection
1. Route the drain hose as shown and press the hose into the
drain hose support.
2. Decide if the drain hose needs to be trimmed. If it does,
trim it.
NOTE: The drain hose connector must not support the
weight of excess hose length. Keep hose as fully extended as
possible.
3. Slip a wire clip over the drain hose.
Push the hose into the drain hose
connector firmly, 5 clicks.
4. Position the wire clip between the
two positioning ribs on the drain
hose connector.
5. Attach the drain hose connector to the garbage disposal
using the supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with a
#8 Phillips head screw at the height shown below.
IMPORTANT: A drain loop must be provided as shown in the
Installation Instructions. Keep hoses as fully extended as
possible to prevent sagging. Any excess length of hose
should be kept on the dishwasher side of the drain loop.
Install the Drain Hose
A drain hose extension kit, part no. 8194400, will extend the drain
hose to a length of up to 141
³⁄₄” (360.05 cm). Do not extend
beyond this length. The maximum drain height is 37
¹⁄₂”
(95.25 cm).
Option 1: Sink drain waste tee connection
1. Route the drain hose as shown and press the hose into the
drain hose support.
2. Decide if the drain hose needs to be trimmed. If it does,
trim it.
NOTE: The drain hose connector must not support the weight
of excess hose length. Keep hose as
fully extended as possible.
3. Slip a wire clip over the drain hose.
Push the hose into the drain hose
connector firmly, 5 clicks.
4. Position the wire clip between the
two positioning ribs on the drain
hose connector.
5. Attach the drain hose connector to the waste tee using the
supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with a
#8 Phillips head screw at the height shown below.
IMPORTANT: A drain loop must be provided as shown in the
Installation Instructions. Keep hoses as fully extended as possible
to prevent sagging. Any excess length of hose should be kept on
the dishwasher side of the drain loop.
drain hose
support
water supply
waste
waste tee
waste
garbage
disposal
valve
valve
water supply
8" (20.3 cm) min. bend
radius from valve
8" (20.3 cm) min. bend
radius from valve
6" (15.2 cm)
minimum
6" (15.2 cm)
minimum
wire clip
drain hose connector
wire clip
drain hose connector
drain hose
support
27-1/2" – 32-1/4"
(70 cm – 82 cm)
27-1/2" – 32-1/4"
(70 cm – 82 cm)
Keep drain hose
straight, as shown.
Keep drain hose
straight, as shown.