KITCHENAID 528534 - Manuel (Page 3)

3
Tools needed:
■ Utility knife
■ Needle-nose pliers
■ Tape measure
■ Flat-bladed screwdriver
■ #2 Phillips screwdriver
■ Side cutting pliers
■ Pencil
■ Sandpaper
■ Level
■ Adjustable wrench that
opens to 1
¹⁄₈" (29 mm)
■ 7 mm socket wrench
■ 5 mm socket wrench
■ 5 mm open end or box end
wrench
■ Electric or hand drill
■ 1
¹⁄₂" hole saw
■ Valve (sized to fit hot water
supply line) with
³⁄₈" male
compression fitting
■ Protective floor covering
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Parts supplied:
Located in drawer:
■ 2 flexible trim pieces (for sides)
■ Edge protection
■ Hose clamp, screw type
■ Washer
■ Drain hose support
■ Drain hose connector
■ Hose clamp, wire type
■ 11, ⁵⁄₈” long, #8 Phillips head wood screws
■ Moisture protection tape
■ 3, 1” hex head wood screws
■ 3, ⁹⁄₁₆” washers
INSTALLATION REQUIREMENTS
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
■ Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
■ Install the dishwasher as specified in these instructions.
■ Have everything you need to properly install dishwasher.
■ Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
■ This dishwasher is manufactured for indoor use only.
■ Install the dishwasher in a cabinet cutout that is level, will hold
weight up to 104 lbs. (47 kg), and is in an area suitable for its
size and use.
Product dimensions
23 ⁷⁄₁₆ "
(59.5 cm)
22 ⁷⁄₁₆ " *
(57 cm)
16 ³⁄₃₂ "
(40.9 cm)
side
attaching
tabs
20 ¹⁵⁄₃₂ "
(52 cm)
drawer open
* If custom wood panels are to be used, the product depth is specified with an
¹¹⁄₁₆" (18 mm) door panel thickness.
NOTE: Product shown with front panels for dimension purposes.
Greatest length from product exit point to hookup (does not
include allowance for drain loop):
■ Drain hose 88 ⁹⁄₁₆” (2250 mm): Extension kit available - part
■ no. 8194400
■ Inlet hose 68
⁷⁄₈” (1750 mm)
■ Power cord 44” (1125 mm)