KITCHENAID KUDE60FVPA - Manuel (Page 16)

16
Install custom panel 8
Customer-supplied
panel
Align top
edges
Drill through
these holes
1-3/8” Screw
Install the two #8-18 x 1 3/8" screws from
the literature package in the top corners of the inner
panel. Tighten the six side screws reinstalled in Step 6.
(Models KUDC03IV and KUDS30IV)
All models require an accessory option to attach custom
panels. Kit Number 8171555 (black), 8171556 (white) or
8171557 (biscuit) are available. To order, call customer
service at 1-800-444-1230.
NOTE: A custom full front panel must weigh no more
than 14 lbs (6.3 kg) and must be made to specific
dimensions. It is recommended that a cabinetmaker cut
the custom panel because of the precise dimensions
needed.
IMPORTANT: Use a moisture resistant sealer on both
sides and all edges of the panel to avoid damage from
humidity.
NOTE: These dimensions are for frameless custom panel
models with a 4” (10.2 cm) console only.
With a TORX ® screwdriver, remove three screws from
both sides, as shown; hold the outer panel up while
removing the screws. Save screws for reinstallation.
Custom panel installation -
Dishwashers with control
panel on the front
23 3/8”
(65.8 cm)
*25 29/32” (65.8 cm)
3/4”
(19.1 mm)
This dimension is for 4” (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6” (15.2 cm). *
1/8” (3.2 mm)
1/8”
(3.2 mm)
1
Install Custom Panel – Option 2
6”
(15.2 mm)
Hex Head
Screw
Attach handle 5
Attach outer panel to back of customer-supplied custom
panel with the four #10-16 x 3/8" hex head screws supplied
in the literature package. Attach the handle. The handle
should be centered on the front of the customer-supplied
custom panel in the area shown.
IMPORTANT: Screw heads must be flush with back of
customer-supplied custom panel.
Attach the panel assembly to the door by reinstalling the
three screws on each side; do not tighten completely. This
reinstallation of the three screws will hold the panel
assembly in place on the door frame.
Align the top edge of the customer-supplied custom
panel with the top of the console.
Drill two 3/32" pilot holes 1/2" (13 mm) deep, into the
customer-supplied custom panel, through the holes in the
top corners on the inner panel, as shown.
Attach body panel 6
Customer-supplied
panel
Align top
edges
Reinstall
3 screws
each side
Install custom panel 7
Customer-supplied
panel
Align top
edges
Drill through
these holes