KITCHENAID KUDC24SE - Manuel (Page 21)

21
The Cycle Monitor allows you to see what
portion of a cycle your dishwasher is in. The
Clean light glows when a cycle has finished.
All other lights will turn off. The Clean light
will turn off when you open the door.
Water Heating Light
The Water Heating light glows while water in
the dishwasher is
heating. Wash or rinse
action continues while
the water heats.
WATER HEATING
DRY CLEAN RINSE WASH
CYCLE MONITOR
RINSE AID EMPTY
Rinse Aid Empty
Fill the rinse agent dispenser when Rinse
Aid Empty is lit to
improve drying and
prevent spots or
streaks.
Using child lock
To turn Child Lock on
Press Energy Saver Dry for 5 seconds. The
Child Lock light will glow for 30
seconds. All other lights will be off.
The Child Lock light will turn back
on for 30 seconds if any pad
is pressed during this time.
To turn Child Lock off
Press Energy Saver Dry again for 5 seconds.
The Child Lock light will turn off.
Child Lock Light
Use Child Lock to prevent your dishwasher
from being turned on
accidentally. No wash
selections or options
can be selected when
Child Lock is on, and the dishwasher will
not start.
NOTE: You will still be able to open the
dishwasher door.
During the first 2 minutes of
a cycle
Press new Wash Selection and Option pads.
After the first 2 minutes of
a cycle
1. Press the Cancel pad to drain any water
and to reset the control.
2. Open the door and check the detergent
dispenser to be sure it is properly filled for
the new cycle.
3. Close the door.
4. Press new Wash Selection and Option
pads, then press the Start pad.
NOTE: If the dishwasher will not start, make
sure Delay Hours has not been selected.
CANCEL
Changing a setting
CHILD LOCK
ENERGY
SAVER
DRY
O p e r a t i n g Y o u r D i s h w a s h e r
Control panel lights
Safeguard
against
accidental
start up
Select the
wrong cycle?