KITCHENAID KUDC24SE - Manuel (Page 20)

20
You can cancel a cycle anytime during
the cycle.
1. Press the Cancel pad once, then wait.
The Cancel light will glow. There
is a 5-second pause between
the time Cancel is pressed and
draining begins.
CANCEL
O p e r a t i n g Y o u r d i s h w a s h e r
Canceling a cycle
Option selections
Press a pad to select an option. If you
change your mind, press the pad again to
turn the option off. To select a different
option, press another pad.
High Temp. Wash
Select this option, and water will heat during
the main wash for better cleaning
of heavily soiled dishes. Water
heating is automatic in the wash
portions and final rinse of the
Soak & Scrub cycle, and in the final rinse of
the Normal, Short Wash, and Light China
cycles.
Energy Saver Dry
Use this option to air dry dishes without heat.
For best results, keep the rinse
agent dispenser filled. Under
certain conditions (hard water,
empty rinse agent dispenser,
plastic items in the load, etc.) you might find
some water left on plastics, dishes, and
silverware.
HIGH
TEMP.
WASH
SANI RINSE * Option
The SANI RINSE option raises the water
temperature in the final rinse to
approximately 155°F (68°C). SANI
RINSE is an option with all cycles
except Rinse Only. Depending on
the incoming temperature of your water, cycle
times might be longer when you select SANI
RINSE.
NOTE: The SANI RINSE cycle raises the
temperature of the final rinse to approximately
155°F (68°C), and maintains that temperature
for at least 16 minutes. This high temperature
rinse sanitizes your dishes and glassware in
accordance with the NFS International re-
quirements (#95/480/2480).
Delay Hours
The Delay Hours light glows when the dish-
washer has been set for a delayed
start. The delay light will turn off
when the cycle starts. See “Setting
a delay start” later in this section.
SANI
RINSE
Cancel
anytime
Customize
your cycles
ENERGY
SAVER
DRY
2. Let the dishwasher drain completely.
DELAY
HOURS