Jensen XS1212 - Manuel (Page 2)

Box
Guidelines
XS Series
Jensen recommends that you have your
subwoofers professionally installed. If choosing
to do your own installation, please note the
following:
• Make sure all moving parts and factory
electrical wires are cleared.
• Leave slack in the wire to prevent pulling or
stretching.
• Tie down wires to prevent them from getting
caught or shorted.
• Do not mount subwoofers where they might be
subjected to moisture.
• Correct subwoofer polarity must be used. The
polarity positive side is marked by a (+) sign or
red dot. Subwoofers out-of-phase will have
little bass output.
• Speaker frames will be twisted by installation
on uneven surfaces. This occurs when the
surface is carpeted/padded and screws are
over-tightened.
• If using more than one subwoofers, be sure that
the combined impedance values cannot damage
the amplifier.
• Speaker wire should be isolated from the
vehicle’s electrical system to avoid noise being
picked up by the amplifiers. We recommend
Road Gear or Sound Quest brands of wire.
• Speaker wire should be large enough to carry
the full power of the amplifier. 14 gauge or
larger sizes are adequate.
• Be sure to give your ears a break if you listen
loud. Listening loud for extended periods can
damage your hearing!
Notes
XS1010
Enclosure Data
• Multi-purpose polycone 10"
subwoofer. Designed for
sealed, ported and bandpass
enclosures
• 450 Watts Peak power
handling, 150 Watts RMS
• 40 oz. magnet
• Efficiency of 88dB SPL
(1W @ 1M), Fs=38.8Hz
• Useable frequency response
24Hz-1kHz
• Subwoofers universels de
10 po. à cônes en
polypropy-lène pour
enceintes closes, à évent et
passe-bandes
• Puissance de son maximale
en crête 450 Watts, 150
Watts RMS
• Aimant de 40 onces
• Efficacité de 88dB SPL
(1W @1M), Fs=38.8Hz
• Réponse de fréquence
utilisable 24Hz-1kHz
• Subwoofers de uso múltiple
de 10” con conos de
polipropileno para cajas
selladas, de puerto y de paso
de banda
• Capacidad máxima de
manejo de potencia de 450
Vatios, 150 Vatios RMS
• Magneto de 40 oz.
• Eficiencia de 88dB SPL
(1W a 1M), Fs=38.8Hz
• Respuesta de frecuencia
utilizable 24Hz-1kHz
XS1010: Thiele Small Parameters
Nom. Dia.
8.23 in (209 mm)
( Fs )/( Fo ) Hz 38.8 Hz
( Vas ) 0.92 ft 3 (26.0 ltr’s)
( Qts )=(Qms x Qes)/(Qms + Qes) 0.32
( Qms ) 10.53
( Qes ) 0.33
( Xmax ) 0.157 in (4 mm)
( Pe ) RMS ( Max.) 150W (450 Max.)
( Re ) DC (R) 3.49 Ω
( Sd ) 41.7 in 2 (269cm 2 )
( Cms ) 0.248 x 10 -3 M/N
( Mms ) 2.38 oz (67.5g)
( Bl ) 13.26 Tm
(SPL ) 88dB, 1W/1M
VC dia. 2" (51 mm)
4.7"
(119.38mm)
4.4"
(111.76mm)
9.02"
(229.10mm)
10.08"
(256.03mm)