Jensen PADIN5 - Manuel (Page 7)

5
PADIN5
OPERATION
Basic Operation
Power
Press the POWER button (1) or any other button on the face of the unit to turn the unit on. Press
POWER to turn the unit off.
Volume Control - Driver
To increase the volume for the driver, rotate the DRIVER volume control knob (2) clockwise.
Rotate the DRIVER knob counter-clockwise to decrease the volume.
Volume Control - Passenger
To increase the volume for the passenger, rotate the PASSENGER volume control knob (3)
clockwise. Rotate the PASSENGER knob counter-clockwise to decrease the volume.
Select Driver Source
To select the Driver source, press the DRIVER volume control knob (2). The DRIVER MODE icon
will flash and turn from amber to green, indicating that Driver Mode was selected. Press the
RADIO, DVD or AUX button (press twice for AUX 2) to select the desired source. The selected
source will be indicated on the display. To exit Driver mode, press and hold the DRIVER volume
control knob for 2 seconds.
Select Passenger Source
To select the Passenger source, press the PASSENGER volume control knob (3). The
PASSENGER MODE icon will flash and turn from amber to green. Select the desired source
(indicated on the display). To exit Passenger mode, press and hold the PASSENGER volume
control knob for 2 seconds.
Mute
Press the MUTE button (4) to silence the amplifier. Press MUTE again to resume audio.
Radio Source Button
Press the RADIO source button (5) to select radio input. The illuminated RADIO indicator will
change from amber to green, indicating the selection was made.
DVD Source Button
Press the DVD button (6) to play the audio from the optional DVDB01 DVD player through the
selected speakers. The illuminated DVD indicator will change from amber to green, indicating the
selection was made. An 8-Pin DIN connector and left and right audio input cables allow you to
control the Jensen DVDB01 through the PADIN5.
NOTE: DVD audio is available for non-Jensen DVD players. To access this feature, press
and hold the DVD button (6) for 2 seconds to control audio for any DVD player when the
communication cable is not connected.
AUX Source Button
Press the AUX button (7) once to select AUX 1 input. To select AUX 2, press the AUX button again
while in AUX 1 mode. The AUX 2 indicator on the display will change from amber to green.
AUX RCA Connections
The RCA connections for the AUX input audio channel, labeled AUX IN 1 and
AUX IN 2, are located on the back of the unit.
AUX IR and DVD IR Connections
There are three 3.5mm jacks (one for AUX1, one for AUX2 and one
for DVD IR) on the back of the unit in which you can plug the IR
source signals. The AUX IN device can then be controlled with the
AUX remote through the IR sensor on the front of the PADIN5.
NOTE: If using a wireless remote with the DVDB01, the DVDB01 wired IR connection must
be plugged into the AUX1 IR, AUX2 IR or DVD IR jack.
External PA Source Button
The External PA source can be selected to broadcast the audio from a microphone. To select the
External PA source, press the EXT PA button (8). The illuminated EXTERNAL PA indicator will
change from amber to green, indicating the selection was made.
1
2
3
PADIN5
4
5 6 7
8
12
11
10 9
AUX2 IR AUX1 IR DVD IR