JVC DLA-S15U - Manuel (Page 27)

26
OPERATE
VOL.
PAGE
BACK
PRESET
FOCUS
COMPUTER VIDEO
QUICK
ALIGN. AV
MUTING
MENU/ENTER
OPERATE button
Basic Operations
■ Projector’s buttons
■ Remote control unit
MAIN POWER switch
The following describes the basic procedure for normal use of
the projector.
1 Turn on the MAIN POWER
switch.
ON [ ❙ ]:The main power turns on and the STAND BY
indicator comes on.
Projector’s indicator
2 Press the OPERATE button.
(Or press the remote control’s
OPERATE button for one second
or more.)
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Notes
• After the power is turned on, the screen may be jumbled for a few
seconds, but this is not a malfunction.
• If the light-source lamp does not light up, try to press the OPERATE
button again.
(Or, press the OPERATE button on the remote control for more than
a second.)
■ Turning off the Power
1 Press the OPERATE button.
(Or press the remote control’s
OPERATE button for one second
or more.)
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode.
2 Turn off the MAIN POWER switch
after the STAND BY indicator
changes to steady on.
OFF [ ‡ ‡ ‡ ‡ ‡ ]: The MAIN POWER switch turns off and the
STAND BY indicator goes off.
2 , 1
1 , 2
Remote control unit
Projector
or
Example of the projector’s button Projector
Projector
2 , 1
1. Turning on the Power
* Do not turn off the MAIN POWER switch during cool
down mode (the STAND BY indicator blinking). Turn it
off after the STAND BY indicator becomes on (stand-
by mode).
\
STAND BY
(ON)
OPERATE
OPERATE
(ON)
OPERATE
(ON)
STAND BY
(Blinking)
STAND BY
(OFF)
\
\
STAND BY
LAMP
TEMP
EMERGENCY
VIDEO
COMPUTER
SETTING
QUICK
ALIGN.
- 2
+ 3
OPERATE
STAND BY indicator
OPERATE indicator
OPERATE button
S15U/EN[26-33] 99.12.22, 13:32 26