To use, Turn control knob to off when finished, Panel kits – Jenn-Air Indoor/ Outdoor warming drawer JWD2030WS Manuel d'utilisation

Page 7: Accessory), Warming drawer care, Drawer slides, Warming drawer, To remove, Open drawer to its fully open position, Locate the black tabs on both sides of the drawer

Advertising
background image

7

To Use:

1. Push in and turn control knob to the SLOW ROAST zone and

set the desired temperature, LOW or HIGH. Preheating is not
necessary.

2. Place food into warming drawer. Food should be placed

directly on the bottom of the warming drawer. Do not use the
rack.

3. Close the warming drawer. Be sure that the warming drawer

is completely closed during operation.

4. Turn control knob to OFF when finished.

Panel Kits

(Accessory)

Panel kits are available for customizing the front of the warming
drawer to match other Jenn-Air

®

home appliances. See the

“Assistance or Service” section to order.

WARMING DRAWER CARE

Drawer Slides

The drawer slides allow you to fully extend the drawer for easier
cleaning. If necessary, the drawer can be removed.

NOTE: Load capacity for the drawer is 100 lbs (45 kg).

Warming Drawer

Remove all items from inside the warming drawer, and allow the
warming drawer to cool completely before attempting to remove
the drawer.

To Remove:

1. Open drawer to its fully open position.

2. Locate the black tabs on both sides of the drawer.

3. Press the tab down on the right side of the drawer and lift tab

up on the left side of the drawer at the same time. Then pull
drawer out another inch to disengage latch.

4. Hold the drawer by the sides (not by the front). Pull it slowly

all the way out.

To Replace:

1. Align the drawer rails with the receiving slides.

2. Push drawer in all the way.

3. Gently open and close the drawer to ensure it is seated

properly on the slides.

General Cleaning

IMPORTANT: Before cleaning, make sure all controls are off and
the warming drawer and the drawer accessories are cool. Always
follow label instructions on cleaning products.

Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.

STAINLESS STEEL SURFACES

To avoid damage to stainless steel surfaces, do not use soap-
filled scouring pads, abrasive cleaners, Cooktop Polishing
Creme, steel-wool pads, gritty washcloths or some paper towels.

Rub in direction of grain to avoid damaging.

Cleaning Method:

Stainless Steel Cleaner and Polish Part Number 31462 (not
included):

See “Assistance or Service” section to order.

Liquid detergent or all-purpose cleaner:

Rinse with clean water and dry with soft, lint-free cloth.

Vinegar for hard water spots

CONTROL KNOB

Do not use steel wool, abrasive cleansers or oven cleaner.

Do not soak knob.

When replacing knob, make sure knob is in the OFF position.

Cleaning Method:

Soap and water:

Pull knob straight away from control panel to remove. Wash,
rinse and dry with a soft cloth.

A. Tab

A. Drawer rail
B. Drawer slide

A

A

B

Advertising